Banshee 10 mil DM Cylinder Billet Crank Complete 611 Big Bore Drag Rebuild Kit

THE BIGGEST BADDEST 10mm BANSHEE BIG BORE ON THE PLANET. 78X64mm CP Industries DM cylinder fully drag ported. Wiseco 78mm forged DM pistons custom made for CPI. +10mm Crankworks billet stroker crank with rods.

Genuine Keihin 41mm PWK Pro Series carbs. UPP DM cylinder carb manifolds.

Terrycable steel braided throttle cable. 8 inch K&N style hi flow filters. Hinson 8 plate drag clutch.

Moto Tassinari V-Force 4 reeds. DM head water inlet and outlet. Billet DM cylinder head domes. Cometic one piece DM cylinder base gasket.

DM cylinder adapter for stock cases. DM Maxlock TITANIUM head studs with nuts. Clutch pusher with bearing mod. Maxlock allen head crankcase stud kit. All parts are brand new. Building this engine must be done by a qualified mechanic with experience building Banshee drag engines. Modifications to your crankcases are required, it runs on race gas or alcohol only, the carbs must be re-jetted and the bike tuned properly, and there additional parts needed for this to run right. It is up to the person assembling, installing, and tuning it to make sure it runs correctly and does not fail. It is a high power, high stress engine and due to the way a drag engine is run parts must be replaced frequently. We are happy to assist you with parts, build the engine, or refer you to the places you need.

Everything is new in the original packaging. PRICES AND LISTINGS ARE SUBJECT TO CHANGE AT ANY TIME WITHOUT NOTICE. DO YOU MAKE A LIVING WORKING ON BIKES? ARE YOU A SHOP OR DEALER. At BPRATV we sell parts from the best names in the industry.

Unless otherwise stated, we will put the quality of the parts we sell up against any other companies' in the industry. Also, we stock the same parts from different manufacturers so that when back orders occur like they have been for the last year we have an alternate part to send that is the same quality. This would be the ONLY reason your order might be slightly different when it arrives.

If you want a certain brand part just ask (if part is back ordered this may cause a delay on your order). 99% of problems can be easily solved without returning the entire order.

Once items have been modified, installed, or used in any way they are not eligible for return. Everything we sell has been tested hundreds if not thousands of times and when installed and tuned correctly they work over 99% of the time.

Part failures happen, but it is rare that it is not due to being installed incorrectly. This product is NOT DIY. Over 99% of people in the world are not qualified to build an engine, and it is the responsibility of the person assembling and tuning the engine to make sure everything works correctly.

It requires special tools and has to be done 100% correct. Many parts must be measured down to. We ALWAYS STRONGLY recommend parts be installed by a qualified, experienced mechanic. If it can not be fixed we will supply you with a new one. Also, we want information from customers when their experience is less than desirable so we know what areas need improvement the most. Please work with us and we will ALWAYS work with you. This item is in the category "eBay Motors\Parts & Accessories\ATV, Side-by-Side & UTV Parts & Accessories\Engines & Engine Parts\Complete Cylinders". The seller is "bpratv" and is located in this country: US. This item can be shipped worldwide.

Modified Item: Yes
Custom Bundle: Yes
Surface Finish: Forged
Manufacturer Part Number: 10467M07800 H120 H016 016-155 V3170B
Modification Description: get banshee DM Cylinder Kit
Placement on Vehicle: Left, Right, Rear, Upper, Lower
Brand: Yamaha Banahsee DM CPI Crankworks Hinson Wiseco
Non-Domestic Product: No
Warranty: Yes
Bundle Description: best banshee 4 mil DM kit